I am not sure what forum this should go in, no matsuura forum..

I stripped a matsuura, I was intending on flogging bits and scrapping the rest but when stripped it was considerably smaller and fits my garage. So now it needs modern, small, electronics fitted.

I didn't note where the air lines went and think a scrounger took some of the airlines[I did say help yourself], so can't forensically work out what went where.

I have a filter/reg/oiler, one take off that is fitered/regulted and one that is filt/reg/oiled. I assume the cylinders[toolchanger up/down and drawbar down] require oiled air. What about the spindle blast, oiled or not?

I am also unsure about draw bar operation, I have a 5/2[is that right] valve and a plain valve that went on the head. How does it operate, push the cylinder down then blast some air down the centre of the piston?
There are two limit switches operaated off the draw bar piston, are they to do with the blast?
At the moment there are no plans for the toolchanger, so thats not a problem.

I didn't think that out very well, I have been going to ask for a while no but assumed I would squirt some air in and see what happens and figure it out..