Good morning, I would appreciate it if someone can help me with the following....when you STOP a job on the controller, it asks you if you want to save the point...how do I save it and how to I retrieve it again to go on?
Thanks a mil!
Conrad

If you press any of the keys from 1-9 it will save the job in that location. To start the job you should press the 'run/pause' button at the same time as the '1 - 9' number button that you saved the stop point in.

You nee to make sure the the line of code displayed is the right one as sometimes it will start at the next point leaving part of a line uncut.

Shannon.

Thanks Shannon...very easy.

Hi Conrad,
I am Diana from Excitech. If you need any other help, you also can contact with our engineer. The e-mail: service@sh-cnc.com
Regards,
Diana

dear sir madam,

I have an excitech cnc router. It has suddenely started to work at extremely high speeds causing damage to the drill. also cutting larger than it is instructed too. could you please give me any solutions. yours sincerely mr george

dear sir madam,

I have an excitech cnc router. It has suddenely started to work at extremely high speeds causing damage to the drill. also cutting larger than it is instructed too. could you please give me any solutions. yours sincerely mr george

I would check the configuration settings are set with the correct step/distance settings.

Shannon.

Hi Geroge,
This is Diana from Excitech. Can you send a e-mail to service@sh-cnc.com? I want to know the details about this situation. And I will ask the engineer to give you the reply.
Regards,
Diana