I need two brackets cut out of 1/2" aluminum plate. They are very simple. They will help finish my cnc router. Below is a picture and a zip file with DFX and 3DM objects. I think they are to scale. The hole in the middle should be 3.22" in diameter and the width of the base should be 4.5". Thanks..........Sam

http://home.comcast.net/~kr4495/temp/MakitaMount.jpg

MakitaMount.zip (http://home.comcast.net/~kr4495/temp/MakitaMount.zip)

:cheers:

I need two brackets cut out of 1/2" aluminum plate. They are very simple. They will help finish my cnc router. Below is a picture and a zip file with DFX and 3DM objects. I think they are to scale. The hole in the middle should be 3.22" in diameter and the width of the base should be 4.5". Thanks..........Sam

http://home.comcast.net/~kr4495/temp/MakitaMount.jpg

MakitaMount.zip (http://home.comcast.net/~kr4495/temp/MakitaMount.zip)

:cheers:

Sorry wrong button

If you haven't found someone to do this give me a shout. hobbymachine@mchsi.com
www.hobbymachine.net

Hi,

What kind of tolerance do you need on the hole and
center to the flat at the back?
I am assuming the other surfaces can be +/-.02 and
no preference for the grade of aluminum.

How fast you want them?
Where would you like them shipped?
Can you pay by PayPal?

Ron

This part had been completed.

jmullett made it and did a fine job.
Thanks everyone for your interest.