Guys,

OK, so no one sems to have an answer for the issues I'm having in Wildfire 3 (see other thread).

Does anyone have any decent tutorials or documentation on how to perform volume milling, surface milling etc etc?

Any advice appreciated!

Cheers,

Garth.

Guys,

OK, so no one sems to have an answer for the issues I'm having in Wildfire 3 (see other thread).

Does anyone have any decent tutorials or documentation on how to perform volume milling, surface milling etc etc?

Any advice appreciated!

Cheers,

Garth.

Do you have access to http://www.ptc.com/learning? There is a wide variety of video and documented tutorials as well as classes. Once you learn how to navigate their website you'll find everything you need there.

Do you have access to http://www.ptc.com/learning? There is a wide variety of video and documented tutorials as well as classes. Once you learn how to navigate their website you'll find everything you need there.


Nomad,

I've managed to get permissions to use the PTC support site now - very useful it is too, thanks very much for the advice.

Cheers,

Garth.