hello,
1. One Fanuc make tapedrill center fitted with Fanuc 0ma system having seperate pulse coder for spindle not responding any m-code(command) All axes are running fine. When spindle command ie M03/M04/M05/M19/M29 etc is commanded, spindle start running but m-signal not getting finish and cycle start lamp remain on till the reset key is pressed. If it is possible post me input/output image list of the said machine.
2. Other machine make Makino mc65 fitted with Fanuc 15M system shows "B-axis harware limit" alarm and pallet, atc also not responding.