Hi all,

I am new to this forum and was wondering if there is anyone out there that could give me some advice on converting my Wincnc Shop Sabre to Mach3? I purchased a 3 year old machine that has some problems with the WinCNC and would like to start from scratch with a clean hard drive and Mach3 aas the controlling software. Any advice would be great. Thanks Steve

micros steppers or servos for motors?

change the break out board and pull out the pci card, delete the software and start over with the mach, how much you want for the wincnc?


and what kind of problem would one have to move from wincnc to mach?

jim