Hi! I'm using Mastercam's mpdypth post, and most of it is fine. Two problems: First tool call is output like this (M03T01S2400$) I need a seperate M06 for the tool, I need the tool designated as T0101 (tool number and tool offset) and I need a seperate M03. How do I do this? The next tool calls are OK, except for the tool number as stated above. Thanks! Gregg :rolleyes:

Look at the section that is posting correctly, and modify the first the same way. I know that is a generic answer, but its better than contact your reseller ;) BTW, if you attach your post I will look at it for you, but the best way to learn is to do it....

Steven

i have the Mastercam post if you need it reply

i have 2 mpDyna24 & mpdypth

I have a post for the Dyna Path Deltal controller. (The old Autocon). I have a post that posts out nearly everything I need. I have been able to modify the post to get everything except the tool designation that you are talking about T0101 I'ts somewhere in the fms area, but I can't get it to work.

Phoodieman

If anyone is still active that has this post I would like to borrow it.

FYI: The MPDyna24 is not a Dynapath post.

"If anyone is still active that has this post I would like to borrow it."
Borrow it...:confused::confused:
Are you going to give it back when your done? :):)

I have several posts for Dynapath. You can contact me if you like.

Mike Mattera