New SC125MS Stepper Motor Controller!

<img src="http://www.salemcontrols.com/products/images/SC125MSCaseFrontQuarterLG.jpg">

- Full, half, 1/4, or 1/8 step microstepping
- Up to 2.5A, 30V, for bipolar motors
- Step + Direction inputs compatible with most CNC software
- Select current level with DIP switches or using resistor
- Power on and motor enabled indicator LEDs
- $74.99 Includes cooling fan and ALUMINUM enclosure ($59.99 for board only)
- Connect up to 4 axes to 1 parallel port with $4.99 adapter cable
- Integrated heat sink
- 2.1 mm x 5.5 mm and screw terminal power inputs
- Can be driven by PC or any TTL-level device -- PLC, uController, etc.
- Optoisolated Inputs for Step, Direction, Enable, Microstep Level (2 inputs, 4 levels), Logic GND -- through IDC connector or screw terminal blocks

Full information on the SC125MS is available at http://www.salemcontrols.com/products/sc125ms.html

You guy's have great prices, I like the above driver with a built in fan, great idea.

So that's $75 per axis

Yep -- $75 per axis, and with a $4.99 cable (part # DB25IDC6) you can connect up to 4 of them to one parallel port with no breakout board needed, just plug and play.

We also have a breakout board (part # SCDB25B) that has screw terminals for all the pins plus direct cable connections for the SC125MS controller.

Daniel Miller
Salem Controls Inc.

I checked out the Salem website... I like the products but when you go to ordering.. the products are sold exclusively through XYZ controls who straps on an extra $100. Granted I havn't emailed Salem directly but that was a deciding factor for me. If I can get one for the price on the salem site then sold! As long as the shipping to Bangkok,Thailand doesn't kill me either.. ;-)