If I want to select a single part drawing from a multi-part file drawing in cambam how do i do it and then create the g-code from it. IE ( shark.DXF)

I want to select just a single body from that file drawing and creat the g-code file from that selection only. Or any multi-part drawing for that matter... thank you guys so far you guys have been very helpful....

Select the part

Create a MOP (profile, engrave, pocket etc.)

Right click on the MOP and select Generate Toolpath

Right click on the MOP and select Create Gcode File.

Save g-code file.



If the part requires more than one MOP, then right click on Machining in the tree view and select Create Gcode File, then save.

Thank you very much, Im going to try that. again you guys are very helpful