mallinathan
10-19-2008, 01:08 AM
Dear All,
I am new here and I thank you all for doing this wonderful service.
Recently I came across problem in milling electrodes.The programs were made in two different softwares namely Delcam and Cimatron. All the electrodes milled with Cimatron program showed a line depression on the side wall where this was absent in the electrodes milled with Delcam program. when I enquired the operator told me that the continuous path pogram available in Delecam is not there with Cimatron. Can some one familiar with Cimatron E 8.5 give a solution?
Regards
Mallinathan
I am new here and I thank you all for doing this wonderful service.
Recently I came across problem in milling electrodes.The programs were made in two different softwares namely Delcam and Cimatron. All the electrodes milled with Cimatron program showed a line depression on the side wall where this was absent in the electrodes milled with Delcam program. when I enquired the operator told me that the continuous path pogram available in Delecam is not there with Cimatron. Can some one familiar with Cimatron E 8.5 give a solution?
Regards
Mallinathan