hi, I problem with electrical onload, my machine is mitsubishi DWC90H, it does not have power to cut anything, someone can help me? thanks/victor

Have you ever run an EDM before? There are 3 things to remember about EDMing.
1. Flushing
2. Flushing
3. Flushing

You must keep the dielectric in the cut in order to do any burning!
How is your set up? Does the machine have power to the head in the burn mode?
Give us more information on your situation. Has this machine worked in the past?

Have you ever run an EDM before? There are 3 things to remember about EDMing.
1. Flushing
2. Flushing
3. Flushing

You must keep the dielectric in the cut in order to do any burning!
How is your set up? Does the machine have power to the head in the burn mode?
Give us more information on your situation. Has this machine worked in the past?

hi! thanks for you atention,

if it was working before, but listen to a thunder inside the control and I stop working the unload to the wire, I belive that they can be the source of power, you know if they can be repaired? can be a transistor switching?

hi! thanks for you attention, if it was working before, but listen to a thunder inside the control and I stop working the unload to the wire, I belive that they can be the source of power, you know if they can be repaired? can be a transistor switching?

:confused: Victor your answer unfortunately does not make sense. Is this Mitsubishi Wire EDM machine located in the US, Mexico or Canada? If it is and it is registered with us you can always contact MC Machinery Systems at 630-616-5900 and we will assist you.

Si usted es un orador español escoge por favor opción 6 y usted será conectados con alguien que puede ayudar usted en su idioma

check 15v dc on dc unit or check all power supply