Does anybody have a good Haas post processor that they can send me? I have a TM-1 and am just getting started. Thanks.

hi , i just bought a new tm1 mill from haas. the belt that drives the spindle rides up and down the 2 cogs in clockwise - counterclockwise . it then rubs . haas are to put 2 belts on to cure it . the engineer tried to set the motor screws front and back and this helped but it still moves ad rubs . has anybody seen this before, does anyone know if their mills belt runs in the middle or does it ride up and down the spindle cog , thanks






I SPOKE TO HAAS 2 DAYS AGO , STILL WAITING FOR A FORMAL SOLUTION AND RETURN OF 2 EMAILS

yes,i have the same problem for 4 years,makes alot of noise too,its an alignment issue
i never did try to fix it,soon i have to replace the belt and will try to align it better than

as far as a post processor.for what software?i have one for master cam

has anyone got any pics or lins to pics of a haas tl1 or tl2 steady rest , thanks