PDA

View Full Version : drawslides



cncman
05-21-2003, 11:28 PM
Has anyone used drawslides for a sliding table cnc machine? Or even used them for both X and Y?

balsaman
05-21-2003, 11:30 PM
I have not but have heard they work ok but can be a pain to keep clean. Once the dust get's in them (and it will) they can get rough.

Eric

WOODKNACK
05-22-2003, 01:32 AM
I have used them. go check out my web page under cnc photos. I couldnt keep the table from slowly moving up and down. They are not precsion slides.