shelburnebri
10-01-2008, 04:49 PM
Using avanced turning V11. On a bore after the profile is finished (which is good) the rapid movement would crash the part is there any thing I could do about this. OD turning has the same issue
|
View Full Version : Rapid Movement after profile shelburnebri 10-01-2008, 04:49 PM Using avanced turning V11. On a bore after the profile is finished (which is good) the rapid movement would crash the part is there any thing I could do about this. OD turning has the same issue dcoupar 10-02-2008, 12:43 AM Are you placing a point to retract the tool to after the profile? |