Hello to eveyone,
i am really new to cnc machines and i have a elox-fanuc series n wire cut, i believe that the control is a 6M and i am haveing trouble with the machine communicating with the pc. i have gotten 3 trial postprocessors and none of them seem to be working. i am thinking that its the parimeters in the cnc that i need to change but i do not know what to change them to??? i also dont know what would happen if i changed them back to the parimeters that are in the manual??? Does any one have any suggestions that can be done?
Thanks!!!

The important thing is that your RS232 setting match the PC setting, do you have the parameter description for the 6?
P 024 & 025
You need a 3 wire cable as shown, ignore the 0 parameter settings.
Al.

Al,
I am not exactly sure what the parimeter description is for the 6 i will have to look at it but thanks for the pdf file.
Tom

P24bit 0 = 0/1 is 1 or 2 stop bits
P25 for 4800 baud = 11101111.
Al.

You need to change par 340........you also have to change the setting page.....does your machine have have membrane over the buttons , like a sticker ...or is it like keyboad buttons .....I can hook you up weather its a 6m
or a 6mb...or the O control........the pdf you have is for a mill.......I have a series O elox fanuc with a OM control...........