Hi Everybody,

This is my first post,I am having problem in FANUC make Wire Cut machine of Model-P,
System-6M model -B

Machine works ok in manual mode,no problem in referencing also.
But in auto mode it works up to the blocks having G0 command.
After reading the G01 command in any block it stops at that point only.
Even sometimes it works in that block also.But mostly for few days it stops at that block where G01 is given.

Checked the parameters,found OK.Make memory clear operation and tried but same problem.

Need help !!!!!:confused:

Debadip

When it stops what error code dose it give ....have you tried to re -inatialize the bubble memory.....???

No, there is no alarm .

Yes I have tried to reinitialise and found the same problem.

Regards

Hello

i`v got exactly the same problem have done almost everything i could
anybody got a clue where the error is


the machine is a fanuc model-H and dryrun, G00 works perfect but when i set G01 it just stops on that line i had an service man here but he couldent
findout the reason no alarms or error codes shows

This may sound like a stupid question, but are you using a G94 on the G01 with no feed value?