Hello If George is on could you please give me some info as to what the power requirements are for the spindle drive input, is it single phase or three phase to get the DC output for the spindle drive as I am looking at a machine complete withe spindle motor, drive and boards but no Heidenhain control and servos as I am looking at transfering my Ajax system over to this one, also can you tell me the overall height of the machine and weight and is it a simple job to remove the swan neck head casting as I have not seen inside the covers to see what the main head section is like, as I have a height restriction to get it into my workshop. my e-mail is colin.wildgust[at]virgin.net thanks colin