Hi

I have one EZTRAK 3-axis with version 4.00/5.66 and up , series II REV. AA, I having problems with the machine, when star to run one program at any diferent part of the program the machine stop and turns off (the screen) is only running the spindle, also the machine stop too when a touch the keyboard, we clean the control panel and the keyboard, clean the filter, fans, even use another keyboard, but nothing happen, can you help me please?

Thanks

Chema

shut machine off

First unplug the machine Kboard and plug in regular keyboard inside cabinet.

Reboot and exit to DOS once boo up finishes .

Run C:\DEFRAG.

Then run C:\SCANDISK

If SCANDISK finds/shows errors, you can have it fix them. If SCANDISK can not fix, you may need to replace HDD.

If by chance you have a new HDD that is not of BPT formatting, this could be your problem - BPT format is 504MB ONLY. Larger size format will NOT WORK!!!

When replacing HDD, you have to partition C: drive to 504MB ONLY. or else software will get scrambled as data is stored. You will have to reload software on new HDD from back up disks.

YOu do have B/U disks I hope.