Hi,

I'm trying to pull the bottom of my lead screw apart for a CNC fusion conversion. I believe I need the bracket and bearings (got the deluxe kit/ballscrews) on the bottom end. I got the top bracket off but am trying to figure out the rest. The lead screw has 2 nuts on it with 4 square cuts at 90* intervals. I'm not sure what I need to take this thing apart and could use some advice before I go any further.

Thanks,
Adam

The "X3 Preparation Guide" by arc euro in the UK is what you need!

http://www.arceurotrade.co.uk/projects/prepguides/X3%20Mill%20Preparation%20Guide.pdf