i have an older 7vmc with acramatic 850 control.

i have been able to do some jobs, setting tool offset to top of part for each tool. i must g92 x and y to my referance point. this works ok.

i would like to use the fixture offsets table.

someone was kind enough to send me the g code sheet for an 850sx controller. it may be similar, but there is no explanations for g60 (positioning) or g99 (reset position).

i can get the table recognized with g0 h(), and it apears the h is modal to the end of program.

what is the proper way to call the fixture offset, and use it throughout the program, using say 3 tools?

does anyone remember this older controller?

thanks,
kirkkks