I have just started using an old Talent fitted with a fanuc OM control . Does anybody know how to get the program library up so I can see what programs are on the machine already . It is not patently obvious . I normally use 18T controllers and there is obviously no direct comparison .

Many thanks.

Should be edit mode- program-LIB softkey

Mine is an ot control.

In edit mode,

Press program soft key twice.

each time you press the soft key it should go between the current program and the library.

Thanks DonH . I will try that when I get in to work tomorrow . The 18Ti I use is a lot simpler to use . The control panel on the front of the Talent says that it is an "OM" controller , but when you look on the ident panel on the back of the machine it says that it is an "OT" . Apparently according to a service engineer the "OT" is for turning and "OM" is for milling . Presumably someone has changed the front control panel .

Anyway thanks again . I will let you know how I get on with it .