Hi everyone!

I recently installed SolidCam 2007 R11.1 and was successfly connected to SolidWorks 2008 SP0 installed on my computer. The problem is when I try to open a new CAM part from and existing SolidWorks part, and error message pops up telling me that SolidWorks needs to restart to recover the files ... I don't know what does this mean. However, I restart and retry but the problem keeps happening.

Is this a solidcam problem or solidworks's?

I was told that SolidCam 2007 is not compatible with SolidWorks 2008. Another suggestion was to upgrade SolidWorks to SP1 or SP2 ... Any help from a SolidCam user? ... Or any other CAD software recommendation for my wire cut EDM machine?

Thanks in advance

I think this is a problem with SolidCAM R11.1 as I have had no problems using R11.2 with SolidWorks 2008.

SolidCAM R11.1 was very soon replaced by R11.2 and I am surprised that your reseller did not offer you R11.2.

SolidCAM2007R11.2 SP4 support SW2008!!

Thanks all, I will upgrade to SolidCam R11.2, and see if it works

Thanks Very much for help. SolidCam R11.2 Supports SolidWorks 2008.

Thanks again

do you know what version of solidcam work whith solidworks 2009 ?
thank's by advance
martial

m2d

SolidCam 2008 R12 SP2.1 Worked Successfully with SolidWorks 2009.

hello semo
thank's for the answer.
I will try to find SolidCam 2008 R12 SP2.1
best regard
martial