Please have a look at these two files. Both are same .prt files but operation GENERATED in two different computers having 3 and 3.2 Ghz respectively. Other hardware is same.

I am getting different tool paths. What can be the reason? CPU speed should not be a criteria right?

Thanks and Regards,
Ananth

John(Joyce) i draw your attention in perticular?

CPU speed does not make a difference.

You either have something in the part set differently (parameters, geometry, ...)
Or you have different versions of NX. (i.e. 4.0.1.1 vs 4.0.2; or 32 vs 64bit)

Wow that's weird! have you contacted GTAC?
Are the NX versions Exactly the same?

Very strange!

Yes guys you hit the bulls eye. My version is 4.0.3.3 and the other version is 4.0.0.25

Thats the key, thanks i will update the other system too.