Hoop
08-12-2008, 10:36 PM
http://pic4.picturetrail.com/VOL760/2847831/9063760/329989752.jpg
What are the options on producing the logo in steel as seen in the photo. The photo is a sample I had seen. Another member advised the logo was burned into the steel using EDM.
Also, is there anyone here who would like to do some of this work for me on a regular basis that has the CNC equipment to do it. I will be putting a logo on Stainless tubes and rods. Depth of cut will be in the .010" range. Enough that it will be there and not easily scratched off.
Thank you
What are the options on producing the logo in steel as seen in the photo. The photo is a sample I had seen. Another member advised the logo was burned into the steel using EDM.
Also, is there anyone here who would like to do some of this work for me on a regular basis that has the CNC equipment to do it. I will be putting a logo on Stainless tubes and rods. Depth of cut will be in the .010" range. Enough that it will be there and not easily scratched off.
Thank you