Hi friends,

I m facing a problem in my Fanuc Tape cut W1 Wire EDM, When it is running an alarm 536, U axis Servo alarm is generated. For clearing this alarm i need to restart it and while starting again then i can see alarm 430 and an alarm on v axis pulse coder. i can reset this alarm by reset key and do homing again, but i m getting a difference in the homing by comparded to the last homing value, by this the job also getting spoiled. pls help me to resolve this problem.

With Regards
Anoop

Any body can help me?

Any body can help me?

Hi friends,

I m facing a problem in my Fanuc Tape cut W1 Wire EDM, When it is running an alarm 536, U axis Servo alarm is generated. For clearing this alarm i need to restart it and while starting again then i can see alarm 430 and an alarm on v axis pulse coder. i can reset this alarm by reset key and do homing again, but i m getting a difference in the homing by comparded to the last homing value, by this the job also getting spoiled. pls help me to resolve this problem.

With Regards
Anoop