Hi all,

I have a denford mirac which utilises some form of fanuc. I need to bore out somy ally though it doesn't show how in the instructions.... I know the Gcode is G86 though I'm not sure if the mirac supports this code, and if it does I need to know what else to put in there to cut the right paths in terms of positive or negative coordinates.. Or do I get it to select the boring bar tool and then use a stock removal program with negative x coordinates.....

Arrggghhhhhh too little knowledge, too much machinery lmao:D:D:D

Thanks in advance to anyone who can help me out.

Jools