bilinghm
07-23-2008, 10:43 AM
Just for fun, I tried balancing a coin on the head of my mini mill, running at 7200 RPM. No problem:D
Bill
Bill
|
View Full Version : X2 Mini Mill vibration bilinghm 07-23-2008, 10:43 AM Just for fun, I tried balancing a coin on the head of my mini mill, running at 7200 RPM. No problem:D Bill neilw20 07-23-2008, 12:59 PM That is a still photograph ! I want see a movie. Run it through the speed range and find a speed where things get a bit resonant. bilinghm 07-23-2008, 01:07 PM Honest, the machine is running. The flash freezes things so it looks like a still. Actually, there are a couple of points in the RPM range where a resonance sets in. But it's really smooth at 7,000 plus. Bill cjdavis618 07-23-2008, 01:13 PM My camera does that to. On this Thread, last post, http://www.cnczone.com/forums/showthread.php?t=59683&page=2 Mine was running at the time to or I wouldn't have been able to see the speed on the tach. My camera makes it look dead stopped. it was running at the speed shown. |