can someone tell if they sell some kind of kit for sherline or any other mini
mill . where you can change tools with qiuck disconects instead of the one
where you have to tighten it with an allen wrech.

The Tormach tool system from littlemachineshop.com comes pretty close. You only have to LOOSEN the drawbar, not remove it.

CR.

Is this what you have in mind?

http://www.hightechsystemsllc.com/pt_rapid_changer.html

here are some videos. I have used the system on my Sherline.
works fine.

http://www.hightechsystemsllc.com/links_videos.html

vender of same product:
http://www.cadcamcadcam.com/index.asp?PageAction=VIEWPROD&ProdID=217

Here is an adapter so that any mill (that can accept a 3/8" shank) can use the system
http://www.hightechsystemsllc.com/pt_rapid_changer_adapter.html

:wee:thanks for the info.
yes that is exactly what I am looking for http://www.hightechsystemsllc.com/pt_rapid_changer.html
but that is just a little over my budget.:cheers:
thanks