Hey guys,

I have an issue, minor, but a headache all at the same time. Had an editing issue in program with a macro for toolsetting. Working on a Cincinnati/Lamb hawk 250, Fanuc 21i controller. Our G code prior to position settings was overwritten and we dont remember what it was :confused:. Now that was within the O8k macro, the working macro is an O9100+, which to us is unviewable. First off I know that I can access that program as a view only through parameters, but I dont know which one it is. Secondly I can get her up and running again by viewing that one, because I know that I can at least grab the right G code to rewrite in the O8k program. Any help here would be outstanding !!

3202 bit 4 (NE9) unlocks your 9000 programs

Thank ya, I did use your info, just havent had the chance to pop back on to thank you for it :rainfro:

No problem. Good to know it was helpful.