I will get new x-ballscrew. Old get broken, and fadal 15xt was turn off immediately. How I centering axmotor/ screw for cold start position? Put power on and do cs command, axle motor away from axle, and turn table by hand on to the center mark, and assembly motor on place?
Is that correct way to do it?

The Fadal uses software travel limits. The index mark is on the Resolver/Encoder. The method of setting the cold start position depends if this machine has AC or DC servo motors.

Neal

ooke. motor is glentek inc model gm405uf-ic mtr 0002 ? that all I can see. fadal is -95 year..