Would anyone be able to share a post config file that will work on a Fadal control. I have edited one to use but I cant figure out how to get the feed comands to post in the correct format. (F100 need F100.) Thank you for any information.

if one for FeatureCam would work i could probably do it.

What software are you looking to post from. I have a Mastercam post and a Gibbscam post that I know work.

He said he needed a post for work nc. I don't think any other cam software post will work with work nc, there not interchangable.

If you send your post to cncdanb@gmail.com I will configure it for you and send it back.

Dan (WorkNC user since 1994)

how would i go about getting a post for a fadal vmc 4020 88 hs

Contact your WorkNC reseller. They should be able to help you. You do have maintenance, right?

Savageson, if you contact our office, as long as you are on maintenance, someone would be more than happy to help you. I work for the company and handle Iowa, Wisconsin, Illinois, Minnesota and most of Michigan. If any of you have any questions about WorkNC, I would be happy to answer them.