Fiero Addiction
05-19-2008, 07:10 PM
I found a few good atricles on the subject.
Optimizing consumable life in mechanized plasma cutting
(http://www.thefabricator.com/PlasmaCutting/PlasmaCutting_Article.cfm?ID=975)
Improving plasma cut quality (http://www.thefabricator.com/PlasmaCutting/PlasmaCutting_Article.cfm?ID=1703)
Lots of other good articles on that site too.
Optimizing consumable life in mechanized plasma cutting
(http://www.thefabricator.com/PlasmaCutting/PlasmaCutting_Article.cfm?ID=975)
Improving plasma cut quality (http://www.thefabricator.com/PlasmaCutting/PlasmaCutting_Article.cfm?ID=1703)
Lots of other good articles on that site too.