I Have a okk mcv 460,like the 500. i had the machine running the other day,was fine. Shut it down for some maintence, when started back up got the ready light, then after a few seconds got alarm 1008 oil cooling (head) & 1071 emg LS on. it is stuck in a state emg stop. Cooler seems ok, emg stop button is working. the local guy isn't real familair with the 5000c2 controls. Any help is appreciated.

You should have a EMG> release switch. Hold this up, & hit reset. Then in handle, move all axis off home pos. at least a 1\2 inch. If that wount work, check for a stuck limit switch. The screen may tell you what axis it is.

Thanks for the info, i had tried that. i got a hold of mitsubishi and found out it was a board in the control.

I have a mch 450 and a pcv40. I have manuals for both. I am looking for a "parts" machine. What board do you need?
Bob