Hi,
i searched the forum up and down and can't find the rigth answer for my setup. I have 3 Keling 425 oz motors, 3 KL-5056 and my powersupply is a KL-320-36. I ajusted my power supply up to 41V. No conection between motor and driver would be longer than 9 foot.

What would be the rigth gauge of the conductors of a shielded cable for that connection?

And what would be the higthes amp setting for my motor/driver combination?
The 425oz motors (KL23H286-20-8B) will be wired bipolar parallel...rated at 2.8 amp current/phase...

Thank you for your tips....you guy's are great!!!!!! I have learnd so much here....

Georg

1: 20 or 22 GA wire is ok
2: You can set at 2.7A in the driver for this motor