Ok, so as some of you may have seen in the "Engraving" area on the forum, I have found a nice "cheap" way to scratch engrave using a micro tapping guide. Just in case you hadn't, that thread can be seen here:

http://cnczone.com/forums/showthread.php?goto=newpost&t=57264


This works very well so far and since the tip is hardened, it's holding up very nicely so I thought I'd pass it along to my fellow mini-millers :)

Nice dude, I like the last one :)


-Jason

What is a low cost software to use for engraving? I like your idea.

Phil