Does anyone know if the RS232 DMC1500 series controllers are supported in Camsoft?

AFAIK Camsoft only use the PCI or ISA PC bus interface in their system.
Al

Squarewave,

While, we do offer RS232 controllers, we do not recommend the DMC 1500 for CNC use, because it is too slow and has been discontinued by Galil years ago.

We also offer a variety of models for EtherNet, as well as what Al mentioned the PCI and ISA versions.

Take a look at these plus the low end 4 axes RS232 DSP based motion board at:
www.cnccontrols.com/motionboards.asp

Tech Support
CamSoft Corp.
(951) 674-8100
support@camsoftcorp.com
www.cnccontrols.com