Hi does anyone have pin out info for this hmi ? i can not seem to find any anywhere thanks guys

I have not used the OPS1000 but I presume it is the HMI for the ACR-1000? if so it is most likely uses the serial connection? and you may still get the details from Parker Motion, if you are lucky.
But if all the above applies and it has either a 9 pin or 25 pin socket, then it most likely conforms to the standard RS232 pin-out, and the card only uses 3 pins for RS232 communication, so it should be too hard to find out.
Al.

Thanks AL it seems to be a general hmi. it is at board level now and just has a 14 pin t strip it needs + and - 12 v and serial com i think i will just try to trace it out and try it. no info found at acroloop other than a pic and basic discreption in 2002 cat