Is there any good book or cd out there for post modification? In the old versions of MasterCam there was a seperate book on posts. I have just aquired an old Dyna 4400 mill and would like to get a post modified for this mill. Mastercam has a post for the 2000 series so I will modify this
post . These old Dyna mills did not use standard G&M codes so this will be a challenge . I have never done anthing this extensive in posts so I am floundering. Any help or direction would be great.

Thanks

Jim Walthall

Your dealer should be able to get you a CD for post editing.