Check out this site full of freebeeslink (http://www.metalworking.com/shareware.html) Anyone used any of these programs. Pros/cons? The web page claims as of 11/97 not supported.

I tried danplot when I built my first machine.
It's good for setting up the motor speeds but doesn't use gcodes and X0 Y0 is the center of the drawing not lower left.
If I remember correctly the pin out for the stepper motors are quite different than is currently being used.......................................Jim

On that note, I wonder if there is a new code floating around that would accept simple words to move the machine. Just a thought.

Did you check the DANCAM website for the latest updates?

http://www.dancad3d.com

CHECK THIS GUY OUT http://www.aztec-net.com/~jdemand

heloo
i make a cnc for cut foam amd i use a mm2001 driver doard amd gmfc software,
but i need a new soft for win xp
i cut in 2D and teh drawing make in Corel draw