Is anybody using a rutex 953-000 Z axis control if so does it work well with torch mate software Thanks in advance Kirk

Kirkln,

Are you sure this is the forum you intended to ask your Rutex question? I'm guessing you were intending the Torchmate forum, not the Tormach forum.

Rick

Had a dislexic moment sorry guys how do I move it

I am not aware of any of our customers using this particular height control PCB. The fact that the arc voltage has to be divided to less then 5 volts and that no motor or lifter station is provided sounds like a fair amount of work, to which our Height control will have 10 times the amount of features, perform better in sensing the true arc-voltage, and is a direct bolt on.

Looking at the manual of that unit I believe our system can provide the contact start to initiate the height control's motions.