OK, I'm starting to use deskcnc, what post processor do I use if i'm using deskam and or yeager?

right now when I try to run a file I get a "unknown word starting at r on line 1" error

Paul,

A good one to use is ISO G-CODE. There are a few ISO posts ie: modal and non modal but try the one that comes with the install that just reads ISO_GCODE as its file name, if you are still having problems, send me a copy of your posted file and I will help you fix the problem.

Their is no z codes being produced, so I have to use the post processor and add it manually.