I have some - plastic covered, enamel coated, brass plated, steal - That I need some ovals cut out of. The ovals will be about 1.5" tall by 3.75" wide and I need about 200 of these. The sheats are 1' x 2' x .040" and I will supply. I asume the sheets could be stacked and cut. I will also need the DXF of the oval that is cut - Not the nested file, just of one oval so I can cut a subplate to match the profile.
I am located in the Texas panhandle.
Jimmy, A&S Trophies

Please let me know if you still need a quote I would be happy to provide one
Via waterjet.

thanks
Chris Meurett
www.powerstreamindustries.com
704-888-9930

Yes, I really do. I'm down to a 4 week time frame now and if this will work I still have to make a jig and do the engraving to the plates after there cut. I've been trying to figure out a way to cut these on a mill (all I have) but I believe a water jet would make a nicer plate (less deburing) and be much quicker to do.

Please contact me at 704-888-9930 and we will talk about your needs typically we can turn something like that around very quickly.
We have extensive exp. in cutting a very diverse range of materials
including composites and laminates.
Your welcome to email me also at cmeurett@powerstreamindustries.com

I would be happy to assist

Chris Meurett