I'm not sure if this is the right forum for this, so here goes. I need someone to letter a motorcycle part using a CNC machine. I have the part, what I need is someone who can do this. I also need this done ASAP. If anyone is interested in doing this, email me at RobertMccall@verizon.net and I'll provide the particulars.


Bob

I'll send a note to your email........

Scott

Well, I've received several emails regarding the piece that I need to have done, but, apparently, no takers. Well, this is what I need done and perhaps this will/ might clarify things.

Here's what I need done: Below are a couple of pics of what I am looking for in the way of lettering. the first one is the phrase, GIT -R- DONE, the style & font and the second one is the motorcycle side cover that I need it done on. The font I can work with, but it would have to be along the same lines. Let me know if this is do-able. At the risk of sounding pushy, I also need it done ASAP. The part is already made, but, just needs to be lettered. The working area, within the black circle is about 3.5".
Any takers? I need a quote and a turnaround time. Short of this, any suggestions?

GIT -R- DONE
http://i70.photobucket.com/albums/i117/RobertLC_photos/Git-R-Done.jpg

Inside the black circle is the available work area
http://i70.photobucket.com/albums/i117/RobertLC_photos/DSCN2179.jpg

check your email.

Monte

email me at michael.hesse@hessemachine.com
I could do it this weekend and have it ready to ship Monday.
Thanks Mike

You must not have received my email??

You can reply to me at zcases at frontiernet dot net

I've replied to every email sent in response to my request. After I had replied as to what I had need to have done, I never heard from anyone again. You were the first one I emailed. The emaill addy that I had sent to is: case@uic.com.

You must not have received my email??

You can reply to me at zcases at frontiernet dot net

What type font is this?

Looks cracked!

This is a slightly distressed stencil font. So easy to do. :D

I've replied to every email sent in response to my request. After I had replied as to what I had need to have done, I never heard from anyone again. You were the first one I emailed. The emaill addy that I had sent to is: case@uic.com.

Maybe try this one....... zcases at frontiernet dot net.....unless you already have a source. Looks like at least one is ready to cut it for you. Let me know if you still need it done.