I've emailing back and forth with the designer of Quickstep4 regarding my issue.

As soon as I try to Set the pulsespacer rate through the setup table my pc hangs. I tried installing from a USB drive, CD, C:, etc with no luck.

I re-installed XP on a new Hard drive thinking that I may have some bad sectors with no luck.

I'm looking for some fresh ideas as to what my problem would be. Specs are 700mhz, 20gb hd with 14gb available, and 512mb of ram.

:confused: Thoughts??

Should also add that I have no problems with the software from Quickstep. It will run fine on my other machines but as my luck will have it, the machine it fails to run on, is the one I need.

Got it all figured out a few weeks ago. There was some sort of a hardware glitch with my printer port that I have yet to figure out.

I will say that I am extremely pleased with Craig's software and his support. This program is extremely easy to learn and run!