Hello,

I have also problems using the graphic simulation on Maho 700 with CNC 432 Philips.

In fact, I'm not sure if this CNC controller has this cappability.

Did anybody use it ? And if yes, has anybody a scanned version of the graphic simulation manual ?

Thank you in advance,

Radu

If I can remember, you must add some code and parameters into the actual part program for this to work. I think, codes to define graphic "widow" size, and some other parameters. Best thing to find is an old MAHO CNC 432 training manual. It was one of the best and easiest CNC manuals I have ever seen. I know we have one in our shop. If I can find it I will make it into a PDF.

Hello thebodger@roger,

Thanks for your reply.

If possible, a pdf of the manual (or the chapter with graphic simulation) will be very helpful.

Radu

Here are some PDF files from the training manual. It should be easy to follow