scopEDog
03-21-2008, 12:03 PM
Hey Guys,
Looking for the following panel to be machined from 6061, 4mm (even 1/8" is ok) thick:
Link (http://www.scopeworks.org/images/tm/front.jpg)
Just looking for one piece with chamfered edges on one side, pretty simple job. Can anyone help? Thanks for your time!
-Eddie
Med-Pac
03-21-2008, 01:11 PM
Good afternoon Eddie,
We can do this part for you. We have .125 6061 T-6 on hand, so there would be a quick turn-around (1 week). Including programming, set-up, run-time (milling), and material (with certs if needed); we can do this part for $115.00.
If you don't need a milled quality edge, we can do this part on our plasma for $75.00.
Give me a call or email me at Ph: (218) 238-5100, mbraaten@med-pac.net. Thanks for the opportunity, we look forward to working with you.
Regards,
Mike
Hey Guys,
Looking for the following panel to be machined from 6061, 4mm (even 1/8" is ok) thick:
Link (http://www.scopeworks.org/images/tm/front.jpg)
Just looking for one piece with chamfered edges on one side, pretty simple job. Can anyone help? Thanks for your time!
-Eddie
Kuhlmann75
03-21-2008, 02:01 PM
Hi Eddie,
We are slow right now, and looking for work. We can make the part on a Kuhlmann CNC within .001" tolerance for $50, plus shipping. Where are you located? I've got some 1/8" 6061 aluminum in the back, and can ship this out Monday. Feel free to email me at andy@pecorp.biz or you can call 330-239-2155. We're open Mon-Fri 8 AM till 5 PM EST. Thanks!
Andy Brobeck
Engineering Services
Plate Engraving Corporation
Medina, OH