Med-Pac
03-20-2008, 09:26 AM
Hi,
We've been contacted by a potential customer that needs in excess of 500,000 parts per year. The pcs. will be roughly 4" x 6" x .375. He has suggested swipe stamping, I'm not sure what that is.
My main concern with this possible project is the tolerance he wants to maintain. +/- .002. To get tolerances that tight on a punching fixture, wouldn't you run a greater risk of problems?
Mike
We've been contacted by a potential customer that needs in excess of 500,000 parts per year. The pcs. will be roughly 4" x 6" x .375. He has suggested swipe stamping, I'm not sure what that is.
My main concern with this possible project is the tolerance he wants to maintain. +/- .002. To get tolerances that tight on a punching fixture, wouldn't you run a greater risk of problems?
Mike