I have powered up the controller and then opened up the software. and I get controller not detected. I tried to go in and change the com port and It doesn't reconize the com port, I went in and changed the machine setup for the table size and saved it, still does not see the controller. I have the motors locking and all 3 drives have the red lights on. The control board has the blinking light so it seems that the hardware side is working just no controller. Please HeLPPPPPPP!:confused:

Make sure 2nd Generation controller box is checked in your machine setup. I've also had this happen from trying to use the wrong type of serial cable.