http://www.cs.technion.ac.il/~gershon/NCSim/

Seems to be a very interesting software. Would it be possible to create a IGES from a G code file or did I not understand this rigth??
That would have been a very nice function for me. I really struggle with some STL files but I mannage to make G code programs over these files but i would be much easier to modify a IGES file.

I have downloaded this so I will check it out.

its only a simulation software , you open gcode in it and watch it run , its good to test a program and see what will be produced before actualy running on the cnc machine

Screenshots look good....I'll be trying it out! :beer:

The simulator's screen shots look really good... Thank you for your effort and for sharing

Thanks in advance
hazemeshtine

I did an install and config, but got really funny results. I will try again using the sample gcode supplied, but I didn't understand the setup for simple 2D stuff. Still if I spend more than 10 minutes I may get better results! It was just not immediately real easy to deploy.

I was looking for something like this, thats very cool, thanks

I´m also looking for a free editor like cimco edit for example?

anyone?

http://www.betatechnical.com/autonc.htm
http://www.ncplot.com/

http://www.betatechnical.com/autonc.htm
http://www.ncplot.com/

nice,

thank you.

http://www.cs.technion.ac.il/~gershon/NCSim/

i downloaded the zipfile but it seem to be broken :( could't open it in windows Vista ..