I am using bob cad v22 and on a 3d part i run a z level rough and then an equidistant tool path and when i try to run it in my machine it roughs fine then the equidistant paths try to start at the botom of a cut and work there way up which obviously wont work.basicly instead of the cut starting at 0 and indexing down -.1 to a total depth of -1 it tries to start at -1 and index up to 0 is there a way to correct this

racefast,

Can you post the file?

There is one thing you can check:

Do you have it setup to start on the inside or start on the outside?

Without being able to visualize the part I can not give you specific information. But if you can post it I would be more than happy to have a look.

Regards

it is set to start on the inside would outside be better i attached a screen shot let me know if you need more info i appreciate the help

Can you post the bbcd file? That would allow me to see what it is that is going on with the file. If there are problems with posting it on a public forum let me know...I can give you my email to use.

Regards

what is your email and i will send it

thanks

PM'ed you my email.

Regards